First, the overview of the tablet press The various granular raw materials are pressed into a round piece, which is suitable for laboratory trial production or small batch production of various tablets, sugar tablets, calcium tablets, shaped tablets and the like. The machine for continuous tableting, the machine is equipped with a die, the filling depth of the material, and the thickness of the tablet can be adjusted. The high-speed rotary tablet press has high output, high pressure and continuous pre-pressurization, compact structure, simple operation and maintenance, reliable operation, wide application range of materials, low operating cost, and good cost performance. It also has the advantages of low vibration, low noise, low energy consumption, high efficiency and accurate tablet weight. Second, the working principle of the tablet press Turn the handwheel to raise the lower punch to the highest position, and observe whether the lower punch surface is aligned with the plane of the middle mold (or high or low will affect the output). If not, loosen the butterfly screw and loosen the gear plate to convey the movement. Adjust the gears so that the lower punch surface is aligned with the plane of the middle mold, then press the platen up and tighten the thumb screw. With start, end and speed adjustment. With this option function, it can be reliably and automatically connected with other equipment of the production line, such as sieve, vacuuming, detection, conveying, barreling, etc., to simultaneously complete the pressing production task of the tablet. At the same time, different monitoring methods are adopted on the external equipment, which provides high safety and reliability. Use the on-line detector to remove burrs, flash and remove dust from pressed tablets. Third, the characteristics of the tablet press The vacuum monitoring function uses a flow monitor to periodically detect the suction pressure at a specified position in the suction pipe. Continuously compare the set value with the measured value. If the detector does not detect the suction pressure (no flow) in the suction pipe for 10s, the tablet presser will give a fault alarm prompt and stop running. This function maximizes the reliability of production and continuously removes dust from the tablet press production process. The control technology connected with the whole tablet production line is a new technology for tablet production control. The tableting chamber has 360° no dead angle. The filming mechanism, the lower rail guide and the lower pressing wheel are all specially installed for easy operation, disassembly and cleaning. . Special oil and dust proof system eliminates plugging and increases damping structure. PLC and man-machine interface control, intuitive and easy to operate.