Bp Usp,Propylene Glycol Usp,Mono Propylene Glycol,Dpg Dipropylene Glycol Guangzhou ZIO Chemical Co.,Ltd. , https://www.ziofoodchemical.com
The mold incubator is a test equipment suitable for the cultivation of eukaryotic microorganisms such as molds, because most molds are suitable for growth at room temperature (25 degrees Celsius), and a certain humidity is required for cultivation on a solid substrate, so the general mold incubator is cooled. The system, heating system, air humidifier and culture room, control circuit and operation panel are used, and temperature sensor and humidity sensor are used to maintain the stability of temperature and humidity in the culture chamber. Some special mold incubators can also set the temperature and humidity to vary with the culture time.
Notes and maintenance:
1. During the handling of the mold incubator, it is forbidden to invert and lay flat more than 45 degrees.
2. Do not change the set value frequently during use, so as to avoid overload caused by frequent startup of the compressor and affect the service life of the equipment.
3. When there is no need for lighting in the box, the lighting switch should be placed in the “off†position to avoid affecting the upper layer temperature and prolong the service life of the lamp.
4. This machine is equipped with two sets of fuses. If there is a fault during operation, please cut off the power supply first, check whether the fuse is intact, and then check other parts.
5, in order to maintain the appearance of the equipment, do not wipe the appearance with a corrosive solution, the box can be wiped with a dry cloth or alcohol to keep the inside of the box clean.
6. When the equipment is not in use, keep the inside of the box dry and cut off the power.
7. To ensure uniform temperature inside the box, always check whether the axial fan in the box is running normally. During the experiment, do not over-extrude the contents of the box. Do not block the air outlet of the fan. Space must be reserved to facilitate circulation of the airflow inside the box.
8. Do not touch, touch the temperature and humidity sensor in the box, causing the temperature and humidity to be out of control.
9. If the equipment fails, please ask the professional to repair or contact the sales department of the factory. Users should not arbitrarily dismantle.
Introduction to mold incubator and its notes and maintenance
Introduction to mold incubator: