The tea-picking machine is a kind of harvesting machine. Currently, it is widely used in tea farmer operations, and the tea-picking machine is prone to malfunction. The following is a summary of the failures of the tea-picking machine and troubleshooting guidelines. The tea-picking machine is a crop-harvesting machine that harvests new tender tea leaves from the tops of tea trees. According to the picking method, there are two types of selective tea pickers and non-selective tea pickers. Selective tea pickers have broken and friction type. The former is the use of the principle of bending, picking fresh tea leaves and retaining coarse old branches; the latter uses a pair of elastic fingers to clamp the tea leaves, relying on the static friction between the fingers and the leaves, taking off the new leaves and retaining the old leaves and young bud. Due to the low production efficiency and high requirements for the operation conditions of the tea garden, the selective tea picker has not been widely promoted. Non-selective tea pickers, also known as shear tea pickers, pick tea using the principle of shearing. Because of its simple structure, easy to use and promoted. Sudden downtime may be due to lack of fuel. Check it and fill it up. It is also possible to remove the cap from the spark plug and insert it as it is. If there is a failure to start, first check whether there is fuel, check the intake pipe, carburetor and other fasteners are loose, if loose, tighten. It is also possible that the filter net is blocked and you can clean it up. The technician also said that the spark plug electrode may be damaged or the electrode gap is too large or too small. If something goes wrong, you can replace the new part or adjust the gap of the electrode and adjust it to 0.5-0.6mm. Fault 3 - Insufficient power Insufficient power is mainly manifested in the inability of the engine to work and cutting the tea leaves. The main factor for this failure is that the joints of the fuel pipe enter the air, or the air intake pipe and the carburetor enter the air, and it is necessary to seal or replace the air. Now. Another reason may be that the muffler is clogged and needs to be disassembled and cleaned. Cutting is mainly due to the blade operating speed is too low, the blade gap is too large, the blade wear becomes blunt. Need to be replaced in time. Solve these problems, but also to adjust and maintain some parts of the tea maker. This is what the tea farmers must learn.
romatographic and use double-antibodyromatographic and use double-antibodysandwich method to detect antigen. Whenthe concentration of antigen in specimen ishigher than the minimum detection limit, theviral antigen will form complexes withlabeled antibodies first. Under chromatogra-phy, the complexes move forward along thenitrocellulose membrane till captured bypre-coated monoclonal antibody ofindetection zone.Through the visible color tointerprete the test results.
Antigen Test Kit,Disposable viral antigen detection kit,Antigen antibody test kit,Disposable virus sampling tube Jiangsu iiLO Biotechnology Co., Ltd. , https://www.iilogene.com
Fault 1 - Shutdown during operation
It's also possible that the spark plug electrode is short-circuited, so we just have to remove it and remove it.
Fault 2 - Cannot Start
Failure 4-cutting