Planting process 1. Choose the planting site; 2. Stir the culture material; 3. Pack the culture material; 4. Sterilize at high temperature; 5. Inoculate; 6. Culture. Precautions Every step requires careful attention. Sawdust soaking in advance is beneficial for sterilization. If wooddust is used as the culture material for planting fungus, it needs to be soaked one day in advance. This can improve the effect of high temperature sterilization and sterilize more thoroughly. The fungus planted afterwards is not susceptible to infection. Be cautious about bagging. A good fungus bag should be filled tightly and tightly up and down. The mouth of the bag should be neat and flat. There is no loose material. Drilled out of the bacteria bag. If the mouth of the fungus bag is not sealed, air will enter the fungus bag during the inoculation of the fungus, which is prone to pollution, and the sterilization should be thorough. Qualified bacteria bags will be sterilized at a high temperature on the same day, which will cause miscellaneous bacteria overnight and are prone to fermentation and spoilage. Keep the temperature in the sterilizer at more than 100 ° C, drain the cold air for 10 hours and then bore for more than 3 hours to ensure thorough sterilization. The inoculation should be fast and aseptic. The high-temperature sterilized bag must be cooled to below 30 ° C before inoculation, otherwise it may kill the fungus. When you inoculate fungus, you have to move fast, and you must ensure that it is carried out in a sterile environment. After the inoculation, put the bacteria bag into the culture room and you can wait for the fat and tender fungus to grow. Disclaimer: Some articles of this website are transferred from the Internet. If the legal rights of third parties are involved, please inform this website for processing. phone Specifications: Palm Ultrasound Series,Palm Ultrasound Scanner For Vet,Healthcare Handheld Ultrasound System,Handheld Ultrasound Iphone Guangzhou Sonostar Technologies Co., Limited , https://www.sonoeye.com
Display size: 7 inch TFT
Scanning manner: Electronic convex array, electronic linear array
Working frequency: 2.0MHz~10MHz
Display mode: B, B+B, B+M, M, 4B
Scanning range: Convex array 60°~150°
Amplification factor:1.0, 1.2, 1.5,2.0
Gain control: 8 segments TGC and overall gain can be adjusted respectively
Image processing: 8 γ corrections, frame correlation, point correlation, line correlation, digital filtering, digital edge enhancement and pseudo color processing, etc
Image gray-scale: 256 levels
Scanning line number: 512 lines/frame
Frame rate: 30 frames/second
Digital scanning conversion: 512×512×8 bits
Memory capacity: ≥2GB
Conventional measurements: distance, perimeter, area, volume
Obstetric measurement: horses, cattle, sheep, dogs, cats obstetric measurement
Report function: auto make report
Battery capacity: 3000mAH/7.4V,can work more than 2 hours
Display screen: 7" TFT
Output interface: USB port, video.
Overall size: 216mm×147mm×27mm
Total weight: 950g(with battery)
Waterproof: IP65(optional)
Standard Configuration:
Host, convex probe, built-in battery, power adapter, bag.
Optional:
Linear probe, Micro-convex probe, Rectal probe, Backfat probe.